Attaching A Ledger To House With Wood Siding

Cut away the marked area of siding with tin snips.

Attaching a ledger to house with wood siding. Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides. Place a level horizontally on the siding against the bottom of the threshold and center the bubble. A ledger relies on the fasteners and strength of the wood ledger board and rim board of the house to carry the deck live and dead loads. Avoid cutting the house wrap beneath.

Gap between the end of the ledger and the ends of siding and fill it with high quality exterior caulk to keep water from leaking behind the ends of the ledger. Most house framing relies on building elements floors walls roofs being stacked one atop another. Attaching a deck ledger securely is only half the work of installing a ledger. Anchor deck joists to the ledger with joist hangers filling each hole with galvanized joist hanger nails rated for pressure treated wood.

Set the blade depth so you won t cut into the house sheathing below the siding. How to attach a ledger board to a vinyl sided house 1. Step 2 cut away the vinyl siding carefully cut away the siding with a utility knife braced along the edge of the carpenter s square to avoid slicing through the house wrap. Make sure you have enough room to install flashing above the ledger board and allow for at least a space above the decking preventing water from wicking upwards into wood siding.

Then slip flashing behind the siding covering the top edge of the ledger. How to attach ledger board on siding mark the top of the ledger. Start by making an outline on the siding where you want to position the ledger board. These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim.

Next snap a chalk line across the siding the same length of the board. Step 3 add 2 x 8 planks between joists. Trace its top edge onto the siding. Measure the length and width of your deck to attach the ledger correctly.

Locate the rim joist and mark an outline on the siding where you want to position the ledger board using a tape. Set a water level on mark done for the ledger board then make another at a point longer than. 4 place the ledger board flat against the house with its. Mark the ledger length.

Cut a length of metal z flashing. Snap a chalk line cut out the siding and tack up the ledger board. To ensure proper strength a ledger board should be made out of the same size lumber that was used to make the deck joists usually 2 inch by 10 inch boards. Make a mark where the top of the deck should be the mark should be 1 3 inches below that.