Attaching A Ledger Board To A House With Siding
Locate the rim joist and mark an outline on the siding where you want to position the ledger board using a tape measure pencil and chalk line.
Attaching a ledger board to a house with siding. But it held on for dear life. Instead cut off a section of siding so ledger can be in complete contact with house. Measure the exact width and length of the ledger board with a tape measure. Anchor deck joists to the ledger with joist hangers filling each hole with galvanized joist hanger nails rated for pressure treated wood.
How to attach a ledger board to a vinyl sided house. Next snap a chalk line across the siding the same length of the board. Make sure to install flashing under the siding extending over the ledger the flashing prevents the build up of moisture which causes rotting. Cut away the marked area of siding with tin snips.
I was concerned about rot hiding behind the ledger. Then slip flashing behind the siding covering the top edge of the ledger. Step 2 cut away the vinyl siding carefully cut away the siding with a utility knife braced along the edge of the carpenter s square to avoid slicing through the house wrap. Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
The really weak areas was on the other side of the deck. Well not acutally attaching to the siding but to a house with t1 11 siding. Gap between the end of the ledger and the ends of siding and fill it with high quality exterior caulk to keep water from leaking behind the ends of the ledger. Snap a chalk line cut out the siding and tack up the ledger board.
And all the mistakes that could be made the ledger board was just nailed directly through the t1 11. Here are the steps to take when installing a ledger on a home with siding. In order to install the ledger board you usually need to remove the house s siding. These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim.
The original deck was all cedar. Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location. Using a 4 foot level check to make sure the line is straight. Avoid cutting the house wrap beneath.
The chalk line should be about 1 inch below the door that will open onto the finished deck. Measure the length and width of your deck to attach the ledger correctly. Start by making an outline on the siding where you want to position the ledger board.